Klimaire
Package Terminal Air Conditioner (PTAC) and Heat Pump (PTHP) units
are designed to provide year round comfort in hotel, motel, office
buildings, nursing homes, class rooms, apartments, dormitories,
and hospitals.
The broad selection of Klimaire PTAC and PTHP units are ideal for
new constructions and replacement applications. The KTHM package
terminal units are durable, quiet, reliable, and easy to maintain.
Standard features provide maximum flexibility to meet any application
requirement as well as reduce installation and labor costs.
Features
*
Power Cord – Factory supplied power cord with 3-prong grounding
plug and current detection device with reset.
*
All Package Terminal - Units are supplied complete with wall sleeve,
aluminum back grille, factory installed power cord with circuit
breaker, and a drain kit.
*
Memory function to keep unit settings - Upon a power failure all
of the settings are stored.
When the power is restored the unit will re-start in the mode in
which it was previously set. This function eliminates all discomfort
during unattended sleep operation.
*
Compressor restart delay - Prevents short-cycling the compressor
and to extend the overall life of the air conditioner. There is
a 3 minute delay to equalize refrigerant pressures for optimizing
cycling.
*
Evaporator freeze protection - When the evaporator temperature is
too low this vital function prevents the evaporator to freeze by
turning off the compressor to prevent liquid slugging the compressor,
but keeping the indoor fan running continuously.
*
Automatic change over (heat pump models only) - When the outdoor
coil temperature gets too cold the unit will automatically switch
to electric heating and the compressor will shut off. The compressor
will resume operation when the outdoor temperature raises enough.
*
Comfort quick warm-up (heat pump models only) - Once the room temperature
falls 8º F below the set temperature, the compressor in the heat
pump mode shuts off and the auxiliary electric strip heater is turned
on for one cycle until heating set parameters are satisfied.
*
Last generation control panel - Control panel has LED indicators
and push buttons for MODE, FAN, POWER and set points UP and DOWN.
The control can display the temperature either in ºF or ºC.
*
High temperature safety protection - In heating mode the compressor
and electric heater will be switched off once the indoor air supply
temperature becomes too high to prevent any damage to the unit.
*
Easy to clean filter - Pull out long life polypropylene dust collector
filter offers effective air filtration and is easy to clean and
to maintain without opening the intake front panel.
*
Easy to use controls - KTHM control panel is designed for simple
operation. Controls are easy to read, understand, and activate by
the help of LED lights showing current status. This is ideal for
commercial applications eliminating phone calls to floor managers.
*
Customized set point temperature limits provide a restricted range
of temperature control for commercial applications reducing power
consumption of the building.
*
Fresh air intake - Adjustable fresh air intake flap provides the
outside air requirements for commercial or residential applications
with built-in polypropylene dust collector filter.
|